=====Cleaning the Hazard Switch=====
===by whunter===
===8/28/04===

----
**1)** Remove the hazard light switch from the console.
**2)** Use finger nail polish to mark the top side in three locations for reassembly orientation.
http://www.peachparts.com/diy/hazard_switch/picture_a.jpg

**3)** Use a clean flat cloth covered surface to contain the work area.
**4)** Insert a small screw driver into the back side tab area.
http://www.peachparts.com/diy/hazard_switch/picture_b.jpg

**5)** Gently ease the back cover off, watch out for falling parts.
**6)** Use tweezers to remove the shuttle with caps and springs.
http://www.peachparts.com/diy/hazard_switch/picture_c.jpg

http://www.peachparts.com/diy/hazard_switch/picture_d.jpg

**7)** Use a cheap paper on wood type of finger nail file to clean the contact surfaces.
http://www.peachparts.com/diy/hazard_switch/picture_e.jpg

**8)** Set the button to the on position and insert the shuttle, carefully.
**9)** Install the back pin plate, be sure the back is oriented correctly and the bulb will enter the case hole. 
**10)** Gently squeeze the back into place, check the side catches are fully seated.

If you loose a part, buy another switch.

**-whunter**
----
CategoryDiy